SN2 reaction

Research Question: How do different concentrations of nitric acid (measured in molars) with copper powder (grams) affect the rate of reaction (measured in seconds) measured using a stopwatch? Hypothesis: The copper powder placed in the most concentrated amount of nitric acid, measured in molar, will take the least amount of time, measured in seconds, to react compared to the amounts of copper powder in other less concentrated amounts of nitric acid. This is as if the concentration of nitric acid…

quinolines via Friedlander condensation in high to excellent yields at 70 °C under solvent-free conditions. Initially the reaction between 2-aminobenzophenone (1.0 mmol) and dimedone (1.0 mmol), as the model reaction was examined in the presence varying amount of tartaric acid as catalyst and the results are presented in Table 1. The best result was achieved by carrying out the reaction with 15 mol% of catalyst (Table 1, entry 4). Use of a higher amount of catalyst did not improve the yield…

The synthesis of Aa-g-poly(MAA) involve the optimization of various reaction conditions like initiator concentration, monomer concentration, crosslinker concentration, solvent concentration and pH. After the optimization of various reaction parameters the replications were carried-out in triplicates for the reproducibility of the results and statistical of the results obtained. It was performed using the Statistical Package for Social Science (SPSS) version 10. Statistical results of the…

composite has been investigated. For that purpose, the PMMA samples with Al2O3 additive prepared with different percentages(0,15,25,35 and 45) wt.% and different thickness. The experimental results showed that the D.C electrical conductivity increased with increasing the alumina concentrations and temperature. Also the activation energy change with increasing of additional alumina. The dielectric constant, dielectric loss, A.C electrical conductivity are changed with change the concentration of…

conversion of gas oil and yields of the products is expected(Akpa et al. 2010). When the flow rate of gas oil is increased, there is an increase in the heat inflow into the reactor, rate of cracking reactions are high, feed also spends less time in the reactor and hence less endothermic cracking reactions take place. This resulted in a slight increase of the conversion of gas oil from 73% - 74% (Fig 4.5). It was observed that as the flow rate of gas oil to the riser increases from 34Kg/s to…

1-[Cyano(4-methoxyphenyl)methyl]cycloalkanol (VF-I) synthesized through the reaction of p-methoxyphenylacetonitrile and cyclohexanone using aq. NaOH and tetrabutylammonium hydrogen sulfate as PTC. NaBH4 and CoCl2 in 2:1 THF: H2O used for the reduction of VF-I to obtain 1-(2-amino-1-(4-methoxyphenyl)ethyl)cyclohexanol (VF-II). Further, venlafaxine derivative of the amino acid -carboxamide (VFCA-I toVII ) synthesized through coupling of N-Phthaloyl amino acid chloride derivative (2a-2g-…

Introduction and Overview: For this extended essay, I will be working on building and optimizing different sized water rockets to find out the optimum amount of fuel (water) for each the different rocket sizes. I will be measuring the ranges at which each rocket will fly to find out the optimum fuel level. A brief summary of water rockets: A water rocket is made up of a selection of parts to provide its successful launch: the nose cone which will make the rather snub-nosed end of the large…

1. Redox Catalyst Catalyst is defined as a substance that increases the rate of a chemical reaction without changing its chemical composition and affecting the standard Gibbs free energy, by lowering the activation energy of a chemical reaction. It does so by providing an alternative reaction pathway. In redox reaction, the key chemical event is the net movement of electrons from one reactant to the other. The oxidation state of atoms are changed. Transition metal is used as redox catalyst due…

1. Chemical reactions involved in the oxidation of benzene (adapted from Lupușor et al., 1981) In order to achieve such an analysis, a simplified mathematical model of the reactor was used considering a pseudo-homogeneous, one-dimensional, plug-flow reactor. Model equations…

3.1. Chemical composition and monosaccharide analysis Polysaccharide molecules are linked together by water molecules through hydrogen bonds in an aqueous solution. Adding ethanol into aqueous solution of polysaccharide initially dehydrate polysaccharides, enhance intra-molecular hydrogen bonding, cause conformational change and aggregation of polysaccharide molecules, and eventually leads to the precipitation of macromolecular chains, and the following addition of alcohol solvent gradually…