Hot Box Lab Report

Decent Essays
In conclusion, the purpose of The Hot box device is to make it so it can use energy from from the sun to allow the Cocina del Sol Company to bake their specialty cookies while staying eco friendly. My product used aluminum foil and black paper to attract heat to my device and what’s inside of it. We heated up the box by putting it in contact with light. You can do this by letting it sit in the sun or using a lamp or anything that gives off light like one. The results from my experiments displays the temperature of the marshmallow inside of The Hot box. using degrees Celsius at 5,10, and 15 minutes. These results indicates that over time the temperature of the marshmallow increases over time. If the temperature increases, the cookies will bake.

Related Documents

  • Improved Essays

    Calorimetry Lab

    • 523 Words
    • 3 Pages

    An oatmeal can calorimeter was used for the experiment. The way it works is really simple; a glass of water is places in an oatmeal can. The oatmeal can as a hole cut out in the side to place the food that is on fire in. The before and after measurements of the water temputure are taken. The higher the water temputre rose the more calories.…

    • 523 Words
    • 3 Pages
    Improved Essays
  • Improved Essays

    Nt1310 Lab Report

    • 1745 Words
    • 7 Pages

    The Channel EQ and the Compressor are perhaps the most used Plugins on your Channel Strips. To add them to a Channel Strip is as simple as clicking on the Plugin Button ➊ and select them from the Plugin Menu ➋. However, there are faster ways to do that. ➡ Attention There are two Channel Strip Components that are visible by default (you can toggle them in the Channel Strip Component Window ➌ (open as popup menu or Popover window): Channel Strip Components ➌ • Gain Reduction Meter ➍: When the Compressor Plugin (or the Limiter, or Adaptive Limiter) is loaded on the Channel Strip, then this purple meter displays the amount of gain reduction. • EQ Thumbnail ➎: This area displays the frequency curve of the Channel EQ Plugin.…

    • 1745 Words
    • 7 Pages
    Improved Essays
  • Improved Essays

    The process of heat-treating Knife River Flint requires a lot of time, preparation, and materials. The Knife River Flint that was used in this experiment came from Mercer County, North Dakota, which there are five different Knife River Flint Quarries in Mercer County. The three closest quarries to where the Knife River Flint in this experiment was collected are the Crowley Quarries, Medicine Butte, and Dodge Quarry. With the help of Russell Redhorn, a Native American monitor I was working with at the time, we were able to collect a large quantity of Knife River Flint cobbles from an area about eight miles south of Zap, North Dakota.…

    • 718 Words
    • 3 Pages
    Improved Essays
  • Superior Essays

    Lab Report Into Thin Air

    • 864 Words
    • 4 Pages

    Quetext About FAQ Contact Valerie Delucca Professor Di Lauro Biology 109- Anatomy and Physiology 6 December 2016 Into Thin Air Part 1: - Mt. Denali, Alaska, 17,660 Feet People tend to experience dizziness, headache, fatigue, shortness of breath,decrease in brain function, headache, dizziness, frostbite, hypothermia, etc. at higher altitudes due to a decrease of atmospheric pressure. Mark experienced a shortness of breath and could not seem to feel better even when he paused his climb to “take a breather.” This is very common for people who are not accustomed to the difference in pressure because of the difference of altitudes. Same goes for Emily who experienced a headache due to a decrease in oxygen in the air and therefore, in her body.…

    • 864 Words
    • 4 Pages
    Superior Essays
  • Superior Essays

    Pt1420 Unit 5 Lab Report

    • 1875 Words
    • 8 Pages

    Lab #5: Introduction to Metasploit on Kali Linux Team: CRYPTERS 1 d. Why is it usually a bad idea to operate in the Linux environment as root? If you are unfamiliar with the concept of the root user, do a quick google search. It is always a good practice on any operating system to run your applications on a user level and leave the administrative tasks to the root user, and only on a per-need basis. Applications are meant to be run by users with non-administrative privileges.(Power December 4, 2010)…

    • 1875 Words
    • 8 Pages
    Superior Essays
  • Decent Essays

    Pill Bug Lab Report

    • 631 Words
    • 3 Pages

    My hypothesis was that pill bugs would be more attracted to a warmer environment in comparison to a colder one. However, the results of my experiment refute my claim. Initially I thought that the pill bugs would be naturally drawn to the warmer temperatures due to the fact that pill bugs are cold-blooded and need heat to survive but, for this experiment that was not the case. On average, there were 7 isopods in the cold chamber and 2 in the warm one. At the most there were 8 isopods in the cold chamber, whereas in the warm chamber, there was at the most 4.…

    • 631 Words
    • 3 Pages
    Decent Essays
  • Improved Essays

    Name: Sebastian Sak Lab Partners: Tim Gronet TA: Feifei Xu Determining Molar Enthalpy of Dehydration of Sodium Acetate Trihydrate Purpose: In this lab, two solid substances, sodium acetate and sodium acetate trihydrate, will be analyzed for the heat of solution for both processes. This allowed the calculation of the molar enthalpy of dehydration of sodium acetate trihydrate. Calorimetry was used to experimentally determine the heat of solution for both reactions.…

    • 1267 Words
    • 6 Pages
    Improved Essays
  • Decent Essays

    Wv5 Unit 5 Lab Report

    • 252 Words
    • 2 Pages

    The valves were set up so that the water would flow from Tank 2, through the ½” nominal diameter, type L copper pipe, through the needle valve WV5 (Appendix A), and back to Tank 2. WV5 was initially closed. The Honeywell STD 924 DP meter’s pressure tap lines were placed at PT 1, just before the P-1 Sterlings Fluid System Peerless Pump PE50B1, and PT 10, just after WV5. A Fluke 179 multimeter was attached to the DP electrical box. The multimeter was set to read electrical signal in the form of DC current with units of mA.…

    • 252 Words
    • 2 Pages
    Decent Essays
  • Improved Essays

    Unknown Lab Report

    • 1511 Words
    • 6 Pages

    The focus of this lab was to identify an unknown organism based on its characteristics and the results from each of the tests. There will be various of test to choose from in order to identify the unknown organism, which will eliminate numerous possibilities and narrow it down to one. All the fundamental skills that we have learned and practiced in the lab will be used to perform on our unknown such as aseptic technique, microscopic examination, the use of differential media, and determining if it’s positive or negative. Performing aseptic techniques is the most crucial step that requires the utilizing of transferring, inoculating, and storing bacterial cultures and media. Aseptic technique is defined as procedures that prevent contamination…

    • 1511 Words
    • 6 Pages
    Improved Essays
  • Improved Essays

    Based on the results of the control experiments, the interaction between the Calcium Chloride and phenol red are responsible for the high temperature change in the overall reaction. After doing a control experiment with Sodium Bicarbonate and phenol red and noticing that the temperature got colder, only one other chemical mixed with phenol red could be responsible for the warm temperature change that chemical being Calcium Chloride. There was a temperature change that was observed during the individual control labs as seen when calcium chloride was mixed with water it became hotter and when calcium chloride was mixed with the phenol red it also grew hotter in temperature. Though during the lab which mixed phenol red with baking soda the temperature…

    • 1447 Words
    • 6 Pages
    Improved Essays
  • Improved Essays

    Investigating Properties Lab Ishan Godra SCH4U Lab Partner(s): DeSean Lawrence Ms. Boulougouris 10/31/14 Purpose The purpose of this experiment is to analyze the properties of four different types of solids: ionic, polar covalent, non polar covalent, and metallic Hypothesis It is hypothesized the samples which are shown to be insoluble are likely non polar, while soluble samples are polar. Because of the molecular nature of each type of bond, it is hypothesized that polar covalent molecules It is hypothesized that the samples which are insoluble in water are likely to be non-polar molecules or network covalent and the samples which dissolve are either ionic or polar molecules to have dissolved in the water.…

    • 1194 Words
    • 5 Pages
    Improved Essays
  • Improved Essays

    Enthalpy Lab Report

    • 840 Words
    • 4 Pages

    For a calorimeter, a Styrofoam cup place in a beaker is used. The Styrofoam of the cup minimizes heat loss and the beaker keeps the cup in a stable position. Hot and cold water were mixed in the calorimeter to calibrate it and determine its heat capacity, which comes into play in the three reactions tested.…

    • 840 Words
    • 4 Pages
    Improved Essays
  • Superior Essays

    Heat Transfer Lab Report

    • 3086 Words
    • 13 Pages

    Prepared by: Ahmed Alrahmani Prepared to: Dr. Maohong Fan Subject: Heat Transfer from Steam to Water Date: 11/01/2013 Summary:…

    • 3086 Words
    • 13 Pages
    Superior Essays
  • Superior Essays

    Cool water was placed into the calorimeter and its temperature recorded, while an equal weight of water was heated to 35.3 ⁰C. The heated water was immediately poured into the water in the calorimeter and the temperature was recorded. The water equivalent of the calorimeter could then be calculated. Approximately 100 g of cool distilled water was placed into the calorimeter and the initial temperature recorded. Solid sodium sulphate decahydrate crystals of 4.00 g were added to the water in the calorimeter and stirred until it dissolved.…

    • 1185 Words
    • 5 Pages
    Superior Essays
  • Improved Essays

    Chromatin Immunoprecipitation and Sequencing (ChIP-seq) of Heat Shock Factor (HSF) Temporal Binding Sites during the Critical Period of 8-12 Hr After Egg Lay (AEL) in Drosophila melanogaster Embryogenesis Background Heat Shock Response was discovered by the Italian scientist Ferrucio Ritossa, when he saw puffs in the Drosophila polytene chromosome on inducing them with heat. It was later discovered that this Heat Shock Response was regulated by a transcription factor called Heat Shock Factor (HSF). The HSF is responsible for the activation of the Heat Shock Proteins (HSPs) and Heat Shock Cognates (HSCs) genes by binding to their respective promoter region. The HSPs are molecular chaperones that facilitate protein folding, ubiquitin tagging and proteolytic pathways in the cells to prevent the building of proteolytic toxicity.…

    • 860 Words
    • 4 Pages
    Improved Essays