Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
31 Cards in this Set
- Front
- Back
Flourocarbon rubber (such as Viton) is incompatable with... |
HFC refrigerants and is unauthorized |
|
A Dynamic Seal is....
|
a sealing device used between parts that have relative motion (piston,shaft seals)
|
|
A Static Seal is...
|
a seal where there is no relative motion between the seal and any parts in contact with the seal
|
|
Nitrile (or Buna N) Rubber....
|
most resistance to petroleum products
|
|
Butyl rubber...
|
-low permeability rate for gases
-ideal rubber for sealing gases |
|
The most commonly used elastomers have a hardness between....
|
65 and 75
|
|
Explosive decompression is when...
|
gasses trapped in a seal expands after rapid decreas in system pressure causing blisters in seal
|
|
Best elastomers for high temperatures are...
|
silicones, flourosilicones, and flourocarbons
|
|
Keep preformed packings in.....
|
their original envelopes
|
|
Arrange preformed packings so...
|
older seals are used first
|
|
Storing temperatures for packings?
|
60°F-100°F and should not exceed 125°F
|
|
O-Ring seals are considered____type shelf life items
|
type I
|
|
If V-Ring packing age exceeds 10 years...
|
packing should be discarded
|
|
Shelf life of Nitril or Buna N
|
15 years
|
|
Shelf life of Ethylene-Propylene and Flourocarbon rubber
|
unlimited
|
|
Normally, backup rings are required for operating pressures over...
|
1500 lb/in
|
|
Best overall packing used for static applications
|
O-Ring
|
|
Gland face angle must not exceed...
|
5 degree maximum
|
|
Clean thread tube fitting seal using local procedures such as....
|
caustic dip or wiping with clean lint free cloth
|
|
Do not use skydrol based greases with...
|
flourocarbon rubber
|
|
The stretching of the O-ring during assembly usually should be limited to....
|
twice the rings actual size
|
|
When o-ring is installed in final position, the diameter shall have a permanent stretch of no more than...
|
5 percent
|
|
Avoid______ when maneuvering the o-ring into place.
|
rolling or twisting
|
|
Splicing of o-rings are....
|
not usually recommended
|
|
When glueing both ends of a spliced o-ring, hold in contact with firm pressure on the bond for....
|
10 to 30 seconds
|
|
When glueing o-ring splices together, allow adhesive to cure for....
|
30 seconds
|
|
Allow o-ring adhesive to cure at least____before flexing or scratching
|
1 hour
|
|
Anti-extrusion rings are also known as...
|
back-up rings
|
|
The most commonly used backup rings are....
|
tetraflouroethylene (TFE of Teflon) type
|
|
Tetraflouroethylene (TFE) characteristics
|
-impervious to oils and solvants
-resistance to salts and acids |
|
When split ring packing is used, joints shall be staggered....
|
90°
|