Engine Run Eps 12 - 15 Afso 500 (Sj)

Front 1

For no engine shutdown with throttle or Auto Acceleration:

Back 1

- L/R THROTTLE - OFF

- L/R ENGINE FIRE PUSH LIGHT - LIFT GUARD AND PUSH

-L/R ENGINE MASTER - OFF

- IF FTIT IS ABOVE 500 C, DO THE BELOW:

- IF STARTER READY LIGHT IS NOT ON: DO THE BELOW

• STARTER SWITCH - ON

• WHEN N2 RPM IS 40% or LESS, JET FUEL STARTER HANDLE - PULL

- IF STARTER READY LIGHT IS ON, CONTINUE

- L/R ENGINE MASTER - ON

- WHEN N2 RPM IS 30% or LESS, FINGER LIFT - LIFT

- CONTINUE TO MOTOR ENGINE WITH JFS UNTIL FTIT IS 200 DEGREES C OR JFS ENGAGEMENT TIME REACHES 150 SECONDS

- If not able to motor engine, be sure N1 and N2 rotors turn freely before trying to restart.

Front 2

If engine flames out:

Back 2

- L/R THROTTLES - OFF

- If FTIT remains above 500 C

• Motor engine with JFS UNTIL FTIT is 200 degrees C or less, or JFS engagement reaches 150 seconds

• If not able to motor engine, be sure N1 and N2 rotors turn freely before trying to restart engines

Front 3

Engine STALL or STAGNATION recovery procedures:

Back 3

- IF ENGINE STALLS - SNAP THROTTLE TO IDLE

- IF STALL CLEARS, DO EVENT CODE 1020

- IF ENGINE STAGNATES - THROTTLE OFF

- IF FTIT remains above 500 C:

• Motor engine with JFS UNTIL FTIT is 200 C or less, or JFS engagement reaches 150 seconds.

• If not able to motor engine, be sure N1 and N2 rotors turn freely before trying to restart engines

• If engine stalls/stagnates, do event code 1000

Front 4

Recovery from ENGINE OVERTEMP:

Back 4

- IF FTIT EXCEEDS OPERATING LIMITS - SNAP THROTTLES TO IDLE (Mil if in AB)

- IF FTIT DOES NOT DROP AFTER SNAP TO MIL - SNAP THROTTLE TO IDLE

- IF FTIT STILL EXCEEDS LIMITS: THROTTLE - OFF

- IF FTIT REMAINS ABOVE 500 C:

• Motor engine with JFS UNTIL FTIT is 200 C or less, or JFS ENGAGEMENT reaches 150 seconds

• if not able to motor engine, be sure N1 and N2 rotors turn freely before trying to restart engines

- IF FTIT exceeds operating limits, do event code 1070