• Shuffle
    Toggle On
    Toggle Off
  • Alphabetize
    Toggle On
    Toggle Off
  • Front First
    Toggle On
    Toggle Off
  • Both Sides
    Toggle On
    Toggle Off
  • Read
    Toggle On
    Toggle Off
Reading...
Front

Card Range To Study

through

image

Play button

image

Play button

image

Progress

1/28

Click to flip

Use LEFT and RIGHT arrow keys to navigate between flashcards;

Use UP and DOWN arrow keys to flip the card;

H to show hint;

A reads text to speech;

28 Cards in this Set

  • Front
  • Back

EGT Limit for start

635 degrees

Minimum oil Temp for start

-40 degrees

Min oil temp for more than idle thrust

- 10 degrees

Min oil temp for take off

50 degrees

MED Brake - how long after grnd spoilers deploy does braking begin?

2 seconds

LO Mode - how long after grnd spoilers deploy does braking begin?

4 seconds

When does DECEL light come on on auto brake p/b

When deceleration is 80% of the selected rate

AUTO BRK message in wheel SD page does what when disconnected?

Flashes green for 10 seconds

Max tyre speed

195 kts

Amber caution, ECAM Wheel page ‘steering’ means

Either anti skid or NWS have failed, or both

Requirements to arm the auto brake system?

Green HYD sys avail, anti skid , and at least 1 ADIRS available. No fault in brakes system

Requirements for RTO brake operation?

Rto above 72kts for auto spoiler deployment, which triggers auto brakes

T

R

MAX Wiper Speed

230 kts

When are Probes and Windows heated with p/b in AUTO position.

After first engine start

Zone controller primary - primary channel failure. What is target temp and what happens to hot air/trim air valves?

Zones are controlled to 24 degrees. Pack 1 cockpit, pack 2 FWD & AFT cabin temps.


ALTN on ecam

Primary and secondary zone controller failures what temps do packs target?

Pack 1 - 20 degrees


Pack 2 - 10 degrees

Pack controller primary failure? What happens


Gbackup kicks in. Pack flownfixed at previous setting

Primary & secondary pack failure. What happens?

Pack outlet temp no controlled via anti ice valve. Temp will stabilise Between 5 - 30 degrees within 6 mins

MAX Wiper Speed

230 kts

Zone controller primary - primary channel failure. What is target temp and what happens to hot air/trim air valves?

Zones are controlled to 24 degrees. Pack 1 cockpit, pack 2 FWD & AFT cabin temps.


ALTN on ecam

Pack controller primary failure? What happens


Gbackup kicks in. Pack flownfixed at previous setting

Primary & secondary pack failure. What happens?

Pack outlet temp no controlled via anti ice valve. Temp will stabilise Between 5 - 30 degrees within 6 mins

FOB boxed in amber on ECAM fuel page means.

Both transfer valves fail to open, when inner tank it at low level or centre tank pumps fail or are serviced off

How is IDG cooled?

By fuel form the high pressure fuel line in the engine (returned to outer tanks)

Suction valves normally _______by pump pressure

Closed

What do pressure relief sequence valves do?

Ensure when all pumps running that centre tank pumps deliver fuel preferentially

What do pressure relief sequence valves do?

Ensure when all pumps running that centre tank pumps deliver fuel preferentially