Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
22 Cards in this Set
- Front
- Back
If it is necessary to convert a section of flexible duct trunk line to a rectangular metal duct the connection point should be fitted with a?
|
Sheet metal square to round transition
|
|
The thickness of duct insulation is governed by ___________ codes.
|
Municipal
|
|
A transverse joint is used to connect _________ end to end.
|
Ductwork
|
|
Metal ductwork used in heat only application covered with fibrous insulation must be insulated to local code and a vapor barrier added to eliminate ___________.
|
Condensation
|
|
Location of condensate drains is typically covered by ________ codes.
|
Local
|
|
The UMC states that condensate drains must have a pitch of 1/8"" per foot as well as the size and location of the pipe used for _________ drains.
|
Secondary
|
|
What is the minimum diameter of schedule 40 pipe used in secondary drains.
|
3/4"
|
|
The UMC states that secondary drains should terminate in a _________ spot for the homeowner to see.
|
Conspicuous
|
|
The UMC states that an attic-mounted furnace must have a permanently mounted lighting fixture. The switch that controls the light must be located at the required __________ opening.
|
Passageway
|
|
Cloth tape and mastic must be used when sealing interior joints of chases and _________ ducts.
|
Return
|
|
An Extended Plenum Duct system extends in 1 or 2 directions and has multiple ________ ducts
|
Branch
|
|
Fiberglass ducts are connected to sheet metal ducts using ________ and __________.
|
Sheet metal screws and Washers
|
|
The UMC states that All ductwork must be mechanically _______ and ________.
|
Connected and Sealed
|
|
A basic ductboard trunk utilizes 3 _______ grooves and 1 shiplap joint on one corner
|
V
|
|
The shiplap joint of a ductboard trunk must have a ______ in staple flap and stapled with ______" minimum outward clinching staples
|
3in, 1/2in
|
|
Flex ducts should be supported every ______ feet maximum with a metal strap or saddle of 1 1/2" minimum.
|
5
|
|
The maximum sag of flexible duct is ____ per foot.
|
1/2 inch
|
|
When running Flex Duct vertically is must be supported every _____ feet and may not be used as a riser over _______ stories
|
6 feet , 2 stories
|
|
Flex duct may rest on joists as long as the 5 foot rule applies. True or False
|
True
|
|
Pressure sensitive aluminum foil tape can be used on flex or metal ducts. True or False
|
True
|
|
Heat activated aluminum foil tape is used for ductboard joints. True or False
|
True
|
|
Mastic and Glass fabric tape system is used on any mechanical joint metal, ductboard or combination of both.
|
True
|