Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
35 Cards in this Set
- Front
- Back
Dimensions on blueprints are given. |
Centre-Centre |
|
Orthographic means |
2D top, front, and right |
|
The scale for a drawing is located where ? |
Title block |
|
Symbols are used on blueprints for ? |
Simplicity |
|
Isometric drawings can also be called? |
Spool drawings |
|
Contour lines show what on a site plan ? |
Elevations |
|
A top view is also known as a ? |
Plan |
|
The two basic types of blueprint drawings are ? |
Pictorial and orthographic |
|
Pictorial drawings are basically ____ dimensional representations of objects ? |
Three |
|
The three common sub-types of pictorial drawings are ? |
Perspective, oblique and isometric |
|
Perspective drawings are both ? |
Artistic and realistic. |
|
The term isometric means? |
Equal measure |
|
Orthographic drawings are also known as ________ drawings ? |
Working |
|
Three common views for orthographic are? |
Top, front and right |
|
The dimension line is usually placed _______ the actual dimension number. |
Beside |
|
If there is a discrepancy between your scale ruler and the dimensions shown on drawing you should ? |
Use the drawing dimension |
|
Two dimensions for a front orthographic? |
Width and height |
|
Two dimensions for top orthographic? |
Depth and width |
|
Two dimensions for right orthographic? |
Depth and height |
|
The common dimension between front and top orthographic view is? |
Width |
|
The common dimension between front and right side orthographic view is? |
Height |
|
A sectional view is the result of a __________ line? |
Hidden |
|
A section view has cut surfaces which are drawn using __________ lines ? |
Section |
|
Written notes on drawings come in how many distinct types ? |
Two. |
|
What does the term CSI stand for ? |
Construction specifications institute. |
|
Mechanical specifications used to be in which division of the Canada specifications institute? |
15 |
|
Non-isometric lines are _______ drawn to scale? |
Never |
|
A complete set of orthographic views of an object has ______ views ? |
6 |
|
Usually there are ___ views for a single line piping isometric ? |
3 |
|
Horizontal piping drawn isometrically should be drawn at ___• the the paper ? |
30 degrees |
|
Threaded joint fitting line symbols on isometric drawings should be _____ to the _____ Pipe. |
Parallel ... adjoining |
|
The type of Note that applies to the blueprint in general and not a specific item is known as a _________ note. |
General |
|
The type of Note that applies to a specific item and not the blueprint in general is known as a _______ note. |
Local |
|
The type of list that describes the types of symbols that may be used on a particular set of prints is know as a: |
Legend |
|
Another type of list that often is used to describe the types of doors and windows is known as a: |
Schedule |