Ccna 1 Chapter 5 V4.0

Front 1

In an IPv4 enviorment, what information is use by the router to forward data packets from one interface of a router to another?

Back 1

destination network address

Front 2

what information is added during encapsulation at OSI layer 3?

Back 2

Source and Destination IP address.

Front 3

In a connectionless system, which of the following is correct?

Back 3

The destination is not contacted before a packet is sent.

Front 4

Which IP packet field will prevent endless loops?

Back 4

time - to - live

Front 5

Which portion of the network layer address does a router use to forward packets?

Back 5

network portion

Front 6

Using the network in the exhibit, what would be the default gateway address for host A in the 192.133.219.0 network?

Back 6

192.133.219.1

Front 7

If the default gateway is configured incorrectly on the host, what is the impact on the communications?

Back 7

The host can communicate with other hosts on the local network, but is unable to communicate with hosts on remote networks.

Front 8

What is the purpose of default gateway?

Back 8

Identifies the device that allows local network computers to communicate with devices on other networks

Front 9

What type of routing uses information that is manually entered into the routing table?

Back 9

static

Front 10

when the destination network is not listed in the routing table of a Cisco router, what are two possible actions that the router might take? (two answers)

Back 10

The router discards the packet

The router forwards the packet out the interface indicated by the default route entry.

Front 11

What are the key factors to consider when grouping hosts into a common network?

(three answer)

Back 11

Purpose

Geographic location

Ownership

Front 12

What is a component of a outing table entry?

Back 12

the next-hop address

Front 13

which intermediary devices could be used to implant security between networks? (two answers)

Back 13

Router

Firewalll

Front 14

What are three common problems with large network? (three answers)

Back 14

Perfromance degradation

Security issues

Host identification

Front 15

All deices shown in the ehcibit have factory default settings. How many broadcast domains are represented in topology that is?

Back 15

4

Front 16

Which three statements are true about routes and their use (three answer)

Back 16

If the destination network is directly connected, the router forwards the packet to the destination host.

If not route exists for the destination network and a default route is present, the packet forward ed ti the next- hop router.

If the originating host has a default gateway configured, the packet for a remote network can be forwarded using that route.

Front 17

A network adminstartor is troubleshooting a connectivity problem and needs to determine the address that is used to forward network packets out the network, Using the nest-r command, the administrator would identify which address as the address to which all hosts send packets that are destined for and outside network?

Back 17

10.10.10.6

Front 18

A network adminstrator notices that there are too many broadcasts on the network. What two steps can the network administrator take to resolve this problems? (two answers)

Back 18

Replace S2 with a router.

Subnet the 192.168.0.0/24

Front 19

The network in the exhibit is fully operational. What two statements correctly describe the routing for the topology that is shown? ( two answers)

Back 19

192.168.0.2 is next-hop address that is used by

R3 to route a packet from the 10.0.0.0 network to the 172.16.0.0 network.

Front 20

What two characteristic are commonly associated with dynamic routing protocols? (two answers)

Back 20

provide routers with up- to- date routing table

consume bandwith to exchange route information

Front 21

What statement describes the purpose of a default route?

Back 21

A host yes a default route to transfer data to a host outside the local network when no other router to the destination exists.