A Gram stain was then performed to confirm that bacteria #12 was indeed gram-negative and also showed that it was rod shaped. Following the provided flowchart, the oxidase test was then performed in order to test for the enzyme cytochrome oxidase; unknown bacteria #12 tested negative. Finally, the bacterium was grown on an EMB plate, which resulted in no color change; this indicated again that the bacteria did not ferment lactose. After these tests were completed, the results were compared to the provided identification flowchart.…
Initially when unknown microbe #7 was gram stained and observed under the microscope, the color appeared more pink than purple, leading to the conclusion that unknown microbe #7 was gram negative. However, when completing the KOH lysis test, the microbe didn’t become sticky and remained tacky which is how a gram positive KOH test would result. It was decided to double check the KOH lysis test and the second test still yielded the same results as the first, gram positive. The conclusion of unknown microbe #7 being gram negative from the gram stain was an error.…
After, then other biochemical tests were performed that were specific to the gram- negative bacteria to start the identification process of the unknown. The results of the gram negative tests lead to the identification of the bacteria Alcaligenes faecalis. The gram stain procedure was the first test performed by isolating a colony from the pure culture streak plate. The gram stain was followed orderly right from the referenced laboratory manual. The test resulted to be Gram- Negative bacteria from the compound microscope which were pink and rod shaped that can be seen with the 100x objective lens with the oil immersion.…
Several tests were accomplished technically and carefully to identify the unknown # 230 to be M.luteus bacteria. Most of the observed results do match the expected ones, except two tests. The observed results for glucose fermentation and oxidase test did not match the expected results. The expected result for fermentation of glucose test was negative while the observed result was positive.…
Gram Negative Unknown Lab Report #20 BIOL 3444-008 Giang Nguyen TA: Malini Kotak 11/05/2014 Abstract The experiment is conducted in order to identify a randomly given unknown gram-negative microorganism. By comparative analysis of biochemical tests that were performed throughout the semester to find out its characteristics and determine the identification of bacterium out of four potential unknown was given. To figure out the characteristics, T-streak was performed to isolate the sample from broth to a Tryptic Soy Agar plate, along with an additional slant in case something wrong with the original plate that can possibly affect the result.…
After the gram stain procedure the unknown bacteria appeared purple and roughly spherical, when seen through the microscope. Thus, this concluded that the unknown bacterium was gram positive and its cell morphology was cocci. After this, a series of test were conducted in order to identify the unknown. The…
To determine the unknown’s morphology is the first step in narrowing down possible organisms. A MacConkey and Mannitol Salt Agar tests were conducted on the organism and revealed the following. No growth on the MacConkey plate resulting in a gram positive bacteria and the Mannitol Salt Agar result showed it could be Staphylococcus or Micrococcus. (1) A gram stain test was used in determining the shape, size and arrangement of the unknown bacteria (1). The unknown organism is heat fixed onto the slide, in order for the organism to be stained.…
The first step was to streak the bacterium with a sterilized look onto a Mueller Hinten plate. The MH plate was incubated at 37 degrees Celsius for 48 hours. Upon return and observation, the MH plate did not isolate the colony enough to be able to test the bacterium. The professor then handed an alternate 10 that was a pure culture to streak. It was with a sterilized loop that some of the pure culture was taken out and gram stained as directed by the laboratory manual (1).…
There were a few sediment on the bottom of the broth. In addition, the tube 2 have pellicle, a layering of growth, of cells at the top. In this lab, the main purpose of this experiment is to identify the biochemical characteristics of an unknown bacteria by using first the Gram Stain and based on the results of the gram staining, several biochemical tests can be performed to identify with accuracy the unknown bacteria. II. Identification Bacteria are divided into Gram Positive and Gram Negative based on the chemical composition of the cell wall.…
This was allowed to be incubated for 24 hours at 35 degrees Celsius. The observation of color change and gas formation is what ultimately led to the identification of our unknown organism. Results: Dichotomous key Gram Stain: After performing the gram stain, our unknown organism appeared to be pink indicating that it is gram negative and that the morphology is rod shape or bacillus.…
The first test conducted was Gram staining. In the process of Gram staining, a small amount of the cultured bacteria was fixed on a slide with heat. Next crystal violet was used as the primary stain. After rinsing the primary stain, a mordant, Gram’s iodine, was added. Afterward, the slide was rinsed…
Introduction Identifying unknown bacterium is not only vital to microbiology, but also to the medical and pharmaceutical industries in order to treat disease/infection properly. Bacteria are classified and identified to distinguish among strains and to group them by criteria of interest (1). There are several different procedures that can be utilized to identify a bacterium. This includes the oxidation test, gram stain, and catalase test. The purpose of this lab report is to show the understanding of all procedures used to identify the bacterium, and explain how the given results led to the identification of the unknown bacterium.…
Identification of unknown organisms is useful in a wide variety of settings; from clinical diagnostics to environmental monitoring (1). Species of bacteria can differ fundamentally in aspects ranging from morphology to metabolism. Exploiting these differences can allow for identification of unknown organisms. Gross morphological characterizations are crude, and better replaced by more accurate and specific tests. At a fundamental level, tests such as the Gram stain divide bacteria in to two broad categories based on the characteristics of their cell wall (2).…
During the first lab period, The gram stain show that the unknown bacteria was a gram neative rod shaped microbe. After this step was established, this next part was to select the best tests and mediums to determine the unknown bacteria. This medium are use to test the metabolic characteristics of the unknown bacteria. In order to identify the unknown bacteria from other bacterias the following medium was used: MSA plate, SIM plate, nitrate reduction test Nutrient gelatin and Urease broth. For Metabolic tests, only Catalase test were performed on the unknown bacteria.…
Introduction In this lab report I use two different techniques to identify Unknown A and Unknown B bacteria’s. These techniques are gram staining and metabolic testing. I first used Gram staining to distinguished and identify the bacteria’s. Han Christian discovered gram staining in 1882, he had biopsy a patient lung that had pneumonia.…